Please state what firmware and version you are using when stating a problem or explaining how something works. There are numerous versions now in circulation. rOn

I will try to be there Peter glenn - vk3pe

I will explain what I did and it worked for me. Turn ON the radio with the function (encoder push button) pressed and hold it. Watch the screen for messages to reset to factory defaults. Last thing it

Hi Peter VK3YE Ill try listen out for you on the Bitx frequency 7177. maybe just maybe we can QSO... 73 Nick VK4pln

Chuck, don't feel like you are alone. I did the exact same thing, and have a similar post in this forum to prove it! 73, Bill

Hi all I Like to share my rebuild version of the KD8CEC / KN4UD nextion version. The 4.3" Basic and Enhanced displays are now supported. It is a mix of KD8CEC/KN4UD and my PD5DJ Menu's and all

Every few months we have a QRP and homebrew gathering at Chelsea beach near Melbourne. The next is this Saturday, July 28, 3pm near the lifesaving club. This time we're having a "Bring your Bitx

Thank you Ken. kevin

I can change the vfo on the ubitx and it is 270Hz off. K3 output on 28400000 UBitX 28400270 for natural pitch Why does the pitch go back and forth when I try to save it? Michael n2zdb

It says PTT to confirm. I think the number is changing but not the pitch.

I thought I read somewhere after you get the frequency set you have to turn the ubitx off and then back on to save the settings.

Hi Ion, I am using the latest from KD8CEC 1.08. I can get the receiver to sound ok until I try to save it! Thank you, Michael n2zdb

Hi Michael! What firmware are you using? In case you use Ian's firmware I will tell you what I have done to get my uBitX calibrated. Please let me know and I will try to help. 73, -- Ion VA3NOI

I am back troubleshooting my uBITx build and am still trying to get the receiver sounding normal. I was able to use values that other had great success with and now I am at the point where I need to

This same W10 update issue (honey, I lost my comm ports) happened to me twice (how dumb am I?). Well the second time I was prepared and rolled back to the previous version.Rolling back is my

On Sunday, July 22, 2018, 6:20:06 AM PDT, RCC WB5YYM <curtis03@...> wrote: With my radio/engineering skills very much lacking, I

Ken Thanks for the reply. I was wondering if there was a generic problem with elements used in the Baofeng microphones, or if yours was an anomaly? May have to order one just so I can test

Art, I didn't measure the output before replacing the element. I compared it to a microphone from a GE commercial radio and it was much lower with the original, now the audio sounds very close. Ken

Kevin, Mouser# 665-AOM-5024L-HD-R Digi-Key# 668-1596-ND MFG# AOM-5024L-HD-R Ken

Even more important if the boards are to be commercially wave-soldered. _._