Ian I'm about to embark on the nextion journey and see that you support the 2.4 and 2.8 displays. Will the 3.2 work also, albeit with a smaller amount of screen real estate filled? 73 K5KDT Kevin

Those remaining kits where sold weeks ago. Roy WA0YMH

Neophyte question: The code is in several files. May different files be merged into the Arduino IDE as desired?

Tried again to post to kd1jvdesigns. This time I noticed a "Your message will be sent when it's approved by the moderators" at the top of the webpage after submitting the post. So kd1jvdesigns is

FB Alan! Got my fingers crossed. -Don

Don: I am referring to the AGC. My next step is to run shielded cable instead of a twisted pair between the volume control terminals and the the AGC board. Alan

Rowland, With the AGC board mounted so far from the volume control (and right near the high RF area) it might be best to run shielded cable instead of just twisted pair. Some RG174 or similar small

Hi Don - thanks for your speedy assistance. To be clear - what I am hearing when I transmit SSB is RFI - loud garbled sounds from the speaker or headphones, not a clear rendition of my voice. The

I had to replace mine twice due to letting the wrong wires touch. I used one of the hot air rework stations that can be found on ebay for about $ 60 including shipping. Just use the hot air wand and

DuWayne Might work fine but one of my objectives is to reduce parts count to just what is necessary for the functionality I want. That is what drove me to using just one ADC input for the

I am a bit overwhelmed, perhaps. Alan, are you referring to the AGC board, not the "Click eliminator"? I'm not finding where Kees posted any photos of mounting the click eliminator. That would be the

I am integrating my uBitx into an old HA 350 receiver chassis. It has a band switch on it, so I want to program A7 to read the switch. I downloaded several different versions of code to find a good

In case anyone sees a similar issue, I took me a bit of head scratching to figure out what it was. Add to that the random nature of it, more than one cup of coffee was consumed. Either K1 or K3 has

Jerry, don't get too excited, between projects he often goes on extended hikes. He may be gone for a couple of weeks. Roy WA0YMH

Well, I tried to jump in. Clicked the 40M option on his poll, no response. Clicked VoteNow, and it said ThankYouForVoting, but still not in the list an a couple hours later. Tried posting to the

One of the easiest ways to do this might be to use a I2C expander configured something like this board from Microchip https://www.microchip.com/DevelopmentTools/ProductDetails/GPIODM-KPLCD You could

I have exactly the same situation with mine. I hear my voice loud & clear from the speaker, it's like a PA system. It's Kees' kit installed like the photos...a three pin header, center to ground. The

The transmit LPF filter relays only get energized when transmitting. There is no such band switching required when receiving. > My unit came with firmware version 0.2! :( > Why is there such a low

😛

I've got a black dial phone from perhaps the 40's. in the basement somewhere. That would be very cool to have as the UI into my uBitx. Won't want to get just too aggressive with the debouce.