Gary Rindfuss <rindfussg@...>
Greetings i am pretty new here and I want to thank everyone in advance for their help.
I am trying to sort out an issue with a digiboad that I had installed that worked for a while then quit. It had been suggested that I replace the nano board. I ordered some on Amazon. They are the kind where you solder the header pins in so they gave the right way. The chip is marked 328p
I load the v 4.3 sketch on it and when you turn it on you get only "ubitx v4.3 in the display nothing else. (Photo)
I have tried a couple of the nanos and get the same result. I still have the original nano the radio works fine with it it just won't talk to the digi board.
I am sure there is probably something I don't understand about loading a sketch on a new nano board? But the sketch does load without error.
Any help much appreciated