Re: Bitx case design issues #parts #v6 #ubitxv6


Bob Lunsford <nocrud222@...>
 

Some Champ-type crimpers also have screw cutting holes. Some are also metric screw cutters. I shop flea markets for crimpers.

On Monday, June 8, 2020, 9:06:20 PM EDT, Bill Cromwell <wrcromwell@...> wrote:


Hi,

The real problem is the screws reach the bottom of the hole in the
standoff they screw into before the head ever gets to the front panel..
No matter how much of the head you remove the screw will still be too
long. When you saw a limb off from a tree be sure to sit on the trunk
side of the cut instead of the outer side of your cut.

73,

BillĀ  KU8H

bark less - wag more

On 6/8/20 8:14 PM, Bob Lunsford via groups.io wrote:
> If the screen mounting screw headss are standing out from the surface
> too much, I'll run a countersink by hand and make it deeper. This should
> cure that problem.
>
> On Monday, June 8, 2020, 2:50:15 PM EDT, rpremo <rpremo@...> wrote:
>
>
> Here's three issues I am having with full kit case , screws....1. Part
> inventory needed screws dont screw all the way. 2. Screen doesnt mount
> securely its lloose which is a problem for touch display 3. Design of
> screen in relation to volume knob sets up for the screw to secure screen
> interfering with turning knob couple with short volume shaft makes a
> knob not likely possible to secure
>



Join BITX20@groups.io to automatically receive all group messages.