Re: Slowing down Tx to Rx


R. Tyson
 

Hi Evan,

Thanks again I will give that a try . It's the delay in going back from Tx to Rx that I am after altering. It's just to stop the relay changing when using very slow CW.

Reg,          G4NFR

"The value delays the change from transmitting back to receive. As I stated in the prior message, it is in milliseconds, so you would need to enter a value that is large to note a difference. Try 2000 for a 2-second delay.

I am not aware of a way to delay the start of transmission (from RX to TX) if that is what you want.  You could add it to the Nano program.
Reg,

The value delays the change from transmitting back to receive. As I stated in the prior message, it is in milliseconds, so you would need to enter a value that is large to note a difference. Try 2000 for a 2-second delay.

I am not aware of a way to delay the start of transmission (from RX to TX) if that is what you want.  You could add it to the Nano program."

Join BITX20@groups.io to automatically receive all group messages.