Re: tx rx led hook up

Edward Reynolds
 

I used a round file and once the paint is gone inside the led hole it’s a tight fit, but no chance of it falling out. 

Ed N7SNT 


On Oct 12, 2019, at 7:15 PM, Curt via Groups.Io <wb8yyy@...> wrote:

I see the info at ubitx.com run by Sunil. See the category 2 construction ubitx case. Click on the picture. It takes you to page with more pictures, one shows where 3 wires are soldered to bottom of board.

I had to open the mounting hole just a little with a reamer, but I left it with a tight fit.

Curt

Join BITX20@groups.io to automatically receive all group messages.