Re: Spurious Emission Measurement on stock uBitX

iz oos
 

Arv,
I said that on the basis of the results shown in the table by Hiro. At 15m he has shown the biggest spur at 42Mhz not the one Allison first detected on 23Mhz. For the one at 42Mhz a CB low pass should suffice.


Il 17/ago/2018 20:13, "Arv Evans" <arvid.evans@...> ha scritto:
Iz Oos

Might not want to encourage uBITX users to expect that a CB filter will make it legal
on 15 meters.  The 15M spur is in the 23 MHz range so would not be attenuated by
a 30 MHz LPF.

Arv K7HKL
_._


On Fri, Aug 17, 2018 at 9:31 AM iz oos <and2oosiz2@...> wrote:

Hi Hiro, nice analysis, if I understand right if you add also any 30mhz (also like CB) lowpass filter you may transmit on 15m band. Isn't? Is the Trio tuner a simple pi-tuner? I have just done a variable low pass filter with a double 450pf air variable capacitor a six position switch and a 130-7 toroid and looking at PC the results from my antenna analyzer it seems better than expected.


Il 17/ago/2018 16:39, "JJ1FXF" <jj1fxf@...> ha scritto:
Hi, all.

Attached is a PDF file which shows the results of measuing spurious emission on my uBitX which I haven't modified its hardware/software at all.

Here, in Japan, the spurious emission should be less than -50dBc and so the list indicates I can use my uBitX with a Pi-C antenna tuner, but not on 15m unfortunately.

This time, I checked only the CW transmission beccause I had a problem to measure SSB case. It would be very much appreciated if someone could advise to me.

To measure the spurious emission on SSB, at first I need to saturate the PA output by the mic input of so called "pseudo voice" that is 1.5kHz sine wave, and when the output is saturated by increasing the input leve, then 80% of the input level will be used to measuer spurious emission, the Lab guy explained to me.

However, uBitX output won't be saturated which means I couldn't observe the flat level of PA output as increasing the input (pseudo voice) level, but suddenly the output level falls down to a few mW.

The Lab guy said it would be because uBitX didn't have an ALC - Auto Level Controller of the mic input.

So please advise to me how I can saturate the output (PA) level with such a "pseudo voice" input? Maybe bring an external mic compressor? However, how can I observe the flat level of PA output?

Thank you for reading my long email. Hope someone can help me. If you are interested in screen shots of the spurious analyzer, feel free to email me.

BR,

// hiro, JJ1FXF





Join BITX20@groups.io to automatically receive all group messages.