Jack:
Thanks. I am running my customized version which I have been using for a few months. I also tried
the original code, but I get the same exact problem. It would be nice to have a flow chart for the code so I can better understand the flow and figure out where to put in test statements to figure it out. It must be some I/O issue I think because the code is good, and I had to rework the Raduino to change the Arduino. Maybe in the morning I will look for possible shorts on the I/O pins, maybe something it looks at?

Howard

On 8/14/2018 11:35 PM, Jack Purdum via Groups.Io wrote:

If you're using "known" software (e.g., from Dr. Lee or Allard), I would download a "fresh" copy and try again. Also, make sure you are using the latest version of the IDE.

Jack, W8TEE

On Tuesday, August 14, 2018, 11:30:51 PM EDT, Howard Fidel <sonic1@...> wrote:

As I said, the Arduino starts and displays the version number then hangs.

On 8/14/2018 11:28 PM, Jack Purdum via Groups.Io wrote:

Does the "code" hang, or does the "compile process", or does the "upload" hang?

Jack, W8TEE

On Tuesday, August 14, 2018, 11:22:44 PM EDT, Howard Fidel <sonic1@...> wrote:

Yes, and the V4 program I was running before loaded properly.

On 8/14/2018 10:54 PM, Jack Purdum via Groups.Io wrote:

Does it run the sample program named Blink that comes with the IDE?

Jack, W8TEE

On Tuesday, August 14, 2018, 9:45:21 PM EDT, Howard Fidel <sonic1@...> wrote:

I was hopping I could pick someone's brain before I start to experiment with the code I am running on my Arduino. My Arduino nano died, and I just replaced it with a new one. (I tried to socket it, but the pins didn't plug into any sockets I have.) The code hangs at the version number. Is there anything going on that the code looks for that it is not seeing to move on? I know how to add print statements to see if I can locate where the problem is, but if someone has seen this, maybe you could save me some time.
Thanks,

Howard