Attached is my driver it goes between VR1 and the outputs of T10 you need to remove C84 and T10 and insert this circuit. I am using the AMP signal to reduce the overall power output when driving a linear amp which needs 5W not 10W. U7 is a current driver, I chose it because I have a number of them, I probably could select something better, or use an emitter follower but it should do the job at 0 cost for me. The same with the T13-1 transformer, I have them. The opamp was selected for its speed slew rate voltage and current drive capability. C45 is there because U7 needs a minimum load capacitance for stability. I will see if I need to add something there later. TX is the switched 12 volts that is there in transmit only.
I am working on a PCB with this being one part of a daughter board for the uBitx. I would be interested in any feedback. I am not suggesting that this is a cost effective way of improving the uBitx for production. I will post the entire schematic in a few days.

Howard