Re: Newbie instructions for loading software in Raduino #firmware

Jerry Gaffke

Easiest to just clip all the pins to remove the old nano, then extract the pins one by one
using a soldering iron and needle nose pliers.

On Thu, May 17, 2018 at 09:40 am, Ralph Mowery wrote:
The Arduino board is soldered to the other board.  I used  a hot air gun on the pins connected to the other board.  Then one of the solder sucking guns out clean out the holes.If you get an Arduino board make sure you install the pins on the correct side or the board will not fit.
As mentioned before you should be able to connect to the nano board and download programs into it with the power off the ubitx.

Join to automatically receive all group messages.