Re: Newbie instructions for loading software in Raduino #firmware
toggle quoted messageShow quoted text
The Arduino board is soldered to the other board. I used a hot air gun on the pins connected to the other board. Then one of the solder sucking guns out clean out the holes.If you get an Arduino board make sure you install the pins on the correct side or the board will not fit.
As mentioned before you should be able to connect to the nano board and download programs into it with the power off the ubitx.
On Thu, May 17, 2018 at 11:53 AM, kj6etl <pa1zz@...> wrote:
Thanks these instructions will get me going.