Re: Ubitx average SSB output
toggle quoted messageShow quoted text
Howard did you also change out R65 that was posted here too.
By the way the parts showed up here yesterday, thanks a lot. Now to find time to install them.
On Apr 27, 2018, at 09:57, Howard Fidel <sonic1@...
Yes. Change R63 to 24 ohms. The earlier
rev boards had 100 ohms there, and V3 has 47. I put another 47 ohm
resistor in parallel with the one on the board. Now I don't need
to yell into the mic.
On 4/27/2018 3:22 AM, iz oos wrote:
I have checked SSB output for the Ubitx using a Softrock sdr
receiver. The carrier is well aligned and the filter gives a
very good shape. Whistling is gives full output with the stock
mic element. The output seems clean but the average power during
normal speech seems to me a bit low. Is there an easy way to
increase it? 73, Franco
Join BITX20@groups.io to automatically receive all group messages.