Re: Newbie questions...
toggle quoted messageShow quoted text
I think where Allison was going is that these electronic pots usually have a bandwidth that falls in the 10Hz-500KHz plus or minus so they will be limited to use in the audio section. There may be some good reasons to use them in the audio chains though where you can create presets for different band-modes. That could be slick. As for things like drive level… no go. There are some video range digital pots that might work there, but then can be very pricy. For simple controllable voltage ranges… of course a simple Op amp amplifier off an analog pin of the Arduino is more than adequate.
Dr. William J. Schmidt - K9HZ J68HZ 8P6HK ZF2HZ PJ4/K9HZ VP5/K9HZ PJ2/K9HZ
Owner - Operator
Big Signal Ranch – K9ZC
Owner – Operator
Villa Grand Piton – J68HZ
Soufriere, St. Lucia W.I.
Rent it: www.VillaGrandPiton.com
Moderator – North American QRO Group at Groups.IO.
From: BITX20@groups.io [mailto:BITX20@groups.io] On Behalf Of Gerry Hull
Thanks. Yes, I realize the digital pot work.. should not be too hard and the parts are cheap.
On Sat, Apr 14, 2018 at 7:47 PM ajparent1/KB1GMX <kb1gmx@...> wrote:
12v power is external. I have some 2 and 432 to 10m transverters I could throw I;as well