Re: how to reset the calibration

Tim Gorman
 

Jacob,

This sounds like what I probably did!

I'm not sure what you mean by "zero the sideband off WWV".

Do you mean set it so it sounds the best?

tim ab0wr

On Wed, 21 Mar 2018 19:37:25 -0700
"Jacob Farnes via Groups.Io" <kk6jtl=yahoo.com@groups.io> wrote:

I made the error of clicking the encoder instead of pushing PTT when
trying to zerobeat WWV while having that high pitched tone come in, I
found that the BFO got a saved shift point up +2kHz.

I ended up sitting down a few weeks ago and working out steps since
it didn't always get saved.

Tune to WWV on the dial
Enter menu
Turn setup on
Reenter menu turn to and select calibrate
Zerobeat the WWV carrier. (May be difficult if BFO is too far off.)
Click PTT.
Click encoder, select set BFO.
Zero the sideband off WWV. (My BFO frequencies were 11.997.0 and
11.995.0 for each sideband it's been 3 weeks) Click PTT to set.
Click encoder, turn setup off.
Wait more than 10 seconds to ensure setting are saved before removing
power.

Due to local noise I made a few attempts to set it correctly on a
local AM station. Usually I set the sideband side wrong, so I had to
go in change the BFO again. Due to rushing myself, I'd click
"Calibrate" instead of "Set BFO" screwing me up to start all over
again.

I need to go look at the code to see if the calibrate function just
adjusts the ppm of the Si5351 or does something else. Either way, I
got put off working on my uBitx until I figured the calibration
routine out.

Join BITX20@groups.io to automatically receive all group messages.