Note: groups.io will be down for maintenance this evening, starting at 2AM Pacific Time (9AM Thursday 10/17/2019 UTC), for up to two hours.
Re: Aluminum enclosure
toggle quoted messageShow quoted text
On Feb 12, 2018, at 3:24 PM, Dave Bottom <ars.kd6az@...
Here is mine in the Hammond 1402DV (V for Vented since the heat sinks are inside.)
It's tight with the Volume Control mounted in between the display and the extrusion. So the PCB is mounted as close as you can get to the right side extrusion, then mark for the display and pot, with the encoder centered between the display and right side.
I used my own connectors for Mic, Headphones and Paddle plus Power Pole power connection all on the rear panel with the BNC antenna connector.
Room to later mount a USB cable as shown, I would have centered the Power Pole connector with the USB rear panel connection.
Join BITX20@groups.io to automatically receive all group messages.