Re: BITX40 TFT DISPLAY CODE - Coding A Control Button - Looking for Assistance to figure out why a Step Tuning button does not work
Jack Purdum <econjack@...>
toggle quoted messageShow quoted text
Go to line 398 which reads:
g_identifier = 0x154;
and add the yellow line and see what happens to the message.
From: Joe <joeman2116@...>
Sent: Sunday, June 18, 2017 7:26 PM
Subject: Re: [BITX20] BITX40 TFT DISPLAY CODE - Coding A Control Button - Looking for Assistance to figure out why a Step Tuning button does not work
text size in line 302,340,376 the sw1, sw2, sw3 now look good - right place right size.
text size in line 850 was a 4 now a 3 - frequency correct size and fits perfect.
The next one is the meter size its to wide when comparing it to your good display. ---- looked where to change value but could not find to make it narrower.
Your good display only goes as wide as the w in sw2.
The msg is till not in correct place - did not find a location where to force it lower
On Sun, Jun 18, 2017 at 1:53 PM, Jack Purdum via Groups.Io <econjack@...> wrote: