Re: PCB designer? Weight issues.
toggle quoted messageShow quoted text
Yes I'd be interested in helping, but have been loaded with quite alot in general. I am experienced some in layout, and should be able to put something together if needed. Unless there is a quicker/easier route that is already in progress, i'd be happy to try though.
Were you thinking of .030 thick pcb or .062? I've used express PCB to get things done in the past and typically just design the board to the size I need, and cut them out, getting multiples out of the fixed size sheets they offer.(PCB 3.8 x 2.5 x .062 thick) The software is all manual place and routing, but for simpler circuits not too bad. Is there a desired connector for J's, or just solder pads to hard wire into?
There are a couple of newer layout design software packages I've been looking at trying out. Things are rapidly evolving in PCB EDA and multiple open source options. Maybe this would be a good time to try one..
Brandon - KD7IIW
On Wed, Jun 21, 2017 at 12:43 PM, Brandon Tibbitts <tibbs327@...> wrote: