On Wed, 2 Dec 2020, Ken Nelson wrote:
> Can you tell if the valves of that cyl are seating completely? Is
> throttleplate being held completely open during test?
And, it's variable venturi.
> Is carb linkage working properly?
right up top, easy to hold the throttle open with your other hand.
> ls valve adjusting screw loose in its threads? Is it
> pushrod or OHC driving the valve? If operated by a rocker arm, is that
> part worn/loose/getting stuck? lf pushrod-operated rocker, is pushrod
> bent/flopping around?
overhead cam, rockers are clamped to eccentric shafts - loosen clamps,
rotate shafts to get deisred lash, reclamp (careful with the torque).
> Are there two springs closing valve - one inside the
> other - that could somehow be broken/binding on each other?
> When did engine last run right? Or has it been stored a long time?
After decades of motorcycles,
in the mid 1960s, Honda made a 2 seater sports car, similar in appearance
to British sports cars. "S600"/"S800", with some less common "S500" and
even "S360" models, even a forward control pickup ("TN360"). Water
cooled, with dual overhead cams, 4 carbs, roller crank, roller wrist pin
bushings, 9.5K redline, etc. Some of the early ones had chain drives in
trailing arms from the rear differential to the rear wheels.
"A design exercise that got out of hand and went into production".
"A poor man's Ferrari"
Constant changes as they tinkered with the design.
Never officially imported into USA, but there are dozens brought over by
In 1969, they introduced a "tiny" car with modified motorcycle
engine design, and mini-cooper like body. It is an air-cooled paraallel
twin, with a motorcycle style crankcase, but with a differential at the
rear of the crancase, and a reverse gear slapped onto the right side.
36HP. I showed one that was out of the car to a motorcycle salvage guy;
he thought that it was some sort of Honda 3-wheeler that he hadn't seen
before, and was shocked when I showed him that it came from a car.
N600 looks a little like a mini-cooper. The N360 is less common.
Some of the N360s and "Hawaiin" N600s did away with the heater, which was
a clumsy piping to the side with a heat exchanger. The non-heater models
were a cross flow head, with efficient routing ot the exhaust, and were
available with a "sportier" cam for a claimed 45HP.
Oversized piston/cylinder sets were once available, and lowering kits.
Z600 is a "sportier" body, introduced in 1972. It is a hatchback, and the
glass falls out of the rear hatch.
The air-cooled Honda 600s were replaced in 1973 by the Honda Civic, a
water-cooled transverse 4 cylinder, similar to the VW Rabbit.
Grumpy Ol' Fred cisin@...