Re: Clearing Slot Max from the Digitrax command station


Dave Sefcik
 

Great info Mike. Does the clearing of loco addresses apply the same way if using a phone throttle? I suspect it does. 

Dave

On Mon, Dec 7, 2015 at 3:07 PM, Michael Romanowski mmroman@... [AlbanyNTRAK] <AlbanyNTRAK@...> wrote:
 


Digitrax command stations have Option Switches that care used to customize their operation.  Command Station option switches should not be changed unless you fully understand what you are trying to accomplish.  Information on these Option Switches is included in each command station's manual.

Be sure that you are changing the correct Command Station Option Switches as the unit can be crippled by closing the wrong switches.  
NEVER CLOSE OPTION SWITCH #1!!

Clearing your Command Station's Mobile Decoder Slots

Most command station problems are caused by filling up the command station's available slots by the following:
1.  Operators failing to zero the speed of unused addresses
2.  Operators failing to release unused locos from their throttles

Once the slots available are full, additional loco addresses can't be selected.  Opeartors will get the "FF" or "Slot Max" message on their throttles. Phantom addresses can be removed by closing the appropriate option switch in the booster.

Closing OpSw#36 will clear all the loco addresses from the slots available in your command station

Many layout owners set OpSw#36 to closed after each operating session to make sure the slots available in their command station are free for the next session to prevent having to do this during the next session.

General Instructions for Closing Command Station Option Switches (for specific instructions for your command station and throttle, see the instruction manual for your equipment:

1.  On the command station, set the MODE toggle switch to the OP (center) position.
2.  Using your throttle go into Switch Mode
3.  Enter the Option Switch number you wish to change
4.  Press the "c" key on the throttle.
5.  You will hear a beep.
6.  On the command station move the MODE toggle down to SLEEP then back up to RUN.  
7.  Using your throttle, turn Track Status back on.





--
Dave Sefcik
Broker Associate
Piretti Real Estate
22 Walker Street
Lenox MA 01240
413-822-8525 (cell)
413-637-1696 (offfice)

"E-mails sent or received shall neither constitute acceptance of conducting transactions via electronic means nor create a binding contract until and unless a written contract is signed by the parties."

Join AlbanyNTrak@groups.io to automatically receive all group messages.