The key is in each line “RFtoIS”. 73, Glenn-KF0ED

Well hello there. Thank you for you info. Yes, I can see my station showing on aprs.fi after I sent out my position. What I do not understand for sure if what I am seeing in the iGate log within

On aprsdirect your call is being seen. Min Standen G0JMS

Hello experts. Kind of iGate rookies questions. How do I know if iGate is correctly setup? I look at the iGate log, I see bunch of information scrolling up but how do I know they even make it to APRS

I knew how to do this once but forgot and can't seem to find it here on on the Wiki. How do I direct Map Tiles to store on my tablet microSD Card? Thanks! Bret/N4SRN

I've looked at the flagged packets and do not see anything wrong with them. You'll have to contact the APRSDirect folks and have them double-check their algorithm for detecting "out of

aprsdirect The error seems to have cleared itself, but is still visible in yesterdays history.

Can you provide the link where aprsdirect is talking about the wrong order? aprs.fi doesn't show any issues and your raw packets look fine as relates to the included timestamps.

using aprsis32 on a win10 machine. When I generate a beacon, message gets highlighted in red only on aprsdirect, and says that it was received in wrong order. tried enabling and disabling timestamp

It is annoying that it is output only without an external TNC/interface. And Yaesu is well known for ignoring suggestions and complaints. They still haven’t fixed the bug where duplicate packets

The FTM400 does have the audio I/O and PTT on the 10-pin connector for an external TNC (or sound card variation). I think the worse part of all of this is that the reviews (such as the ARRL review in

The only way I've gotten my 350 to work is to use a signallink and sound card Tnc or an external Tnc like TT4. I would assume as I don't have the cable for the 400 that you would have to do the same.

Well isn't that nice. Thank you for the prompt response. Sean W9STR

Note: The following is based on my direct knowledge of the FTM-350. I have not heard anything to the contrary for the FTM-400. What you are doing wrong is that you are using a

I am unable to transmit through the program. When I look at CONFIGURE>PORTS>FTM-400(the radio I am using) Xmit Enable is not checked. Even if I check it it will not stay checked, when I look again, it

WELCOME! I assume that since you are in this forum you are referring to using the KPC-3+ with APRSIS32. There are 2 options fro working with the KPC3 and both are explained here: TNC-KPC-3+ -

Thank you Fred. I’ll give it a try. Mike N3MRM

On the one I had, I used a terminal emulator. At the time I used HyperTerminal PE. Now I would use PuTTY. Fred N7FMH

I’m new to aprs. I’m using a ftm100de and kantronics kpc-3 plus. My question is, what computer program should I use to configure the kpc-3, to use with aprs.

Morning James. Well I know everybody would like more info. I just don't have any more to give. If I had more I could probably figure it out too. Shut down Putty and tried to reconnect to