Reduce the number of variables. - And keep reducing until you have identified the issues, or have a proven set that works. With JUST the RT Systems cable (are you sure it is

Ok here is what I have. Windows 8.1 Using USB to Serial Cord on TNC end. It is a RT Systems cable. Do not know how many of the RS232 pins are being used. I have matched the port settings. Cable on Com

forget the KPC. It's been written it needs to be put into KISS mode but I first tried using the common Kantronics modem with aprsisce and never could get it to work. Went through all the pains

Make sure you do NOT have anything connected to the KPC-3+ when APRSIS32 starts (Specifically Winlink or a terminal program). If nothing is connected then . . . More info please: 1. Assume OS is

i'm a REAL newbe, i know next to nothing. i'm currently trying to use arps and finding it confusing.. sorry for not being able to help. kf7uoj

I have been using APRSIS32 with a Signalink Soundcard. I now have a KPC-3+ and can't seem to get it working with the program. How do I get it to recognize the Com Port of the Rt Systems cable. I use

Thank you Lynn! I didn't know about the opacity and now things are easier to read :) KM4KQQ Rick Peron, R.O.W.F OCARES/AEC-Admin

What the other guys didn't tell you is that the left/right arrows adjust the map opacity. Left reduces opacity, increasing transparency. Right increases opacity, reducing transparency. 5%

Ha ha ha ha, Thank you all Been going mad, I know why as well. Laptop it runs on is in a loft at about 185ft above the ground, gets exposed to the weather and has damaged the keyboard, and it

Press the right arrow about 32 times and us know the outcome. Best regards, Fred N7FMH

Try holding the right arrow key for a few seconds. Greg KB3KBR Sent from my Verizon, Samsung Galaxy smartphone

Evening All, Having a few issues with map files which are causing a few headaches. Been using this install for around about 2 years, on and off. I also follow the development updates as well. It

Thanks! I will give that a shot. Matthew KK6EOL

I run Windows 10 for everything and have two APRSISCE/32 open at all times. They never go non-responsive. Neither of them have an RF port, however. Try unchecking Enables / Internet Enabled when

so do I, now they are worth less Steve, kf6wax

I have a roll of forever stamps that are a few years old. Don't have to worry about how much they were. -----------------------------------------From: "Steve kf6wax@... [aprsisce]" To: Cc: Sent:

Hello, I have been using APRSIS/32 on my windows 10 tablet and for some reason it will stop responding. The message is "APRSIS has stopped responding and will close". It does this now at diffrent

FOUND!!! He responded. He did not know he had RF to IS enabled. Mark

Try echolink, I've located a few folks that way

49c? Try 47c = less splurge 73 Steve, kf6wax