Hi I am trying to get a new Robust Packet Igate (VE7OI-10) on HF, 10.1473. I have followed the best instructions I could find when installing the APRSCE 32, the program seems to work, however, I

Thanks All, I've got the program up and maps loaded and location found, I allowed the system to un pack the zip file and that opened up the application file I don't think I'm TX RF but I'm receiving

I don't even have mine on my "C" drive, mine is on J:\Downloads\APRSIS32 The attached picture is how mine is setup, and I have had a bit of trouble with it. Dave N8PU

Are you SURE you actually have the .EXE inside a newly created folder and that you are not double-clicking the .EXE from inside a view of the original .ZIP file which might be on your

Yes, maybe I'm trying to rush it I'll try again and let it cook...Thanks

It's been a while since I've installed the program, but I believe it's trying to download the initial map so you can locate where your station is. Do you have Internet connectivity?

I have the EXE file in a folder off the desk top, when I click on it it allows me to enter my call and ssid enter the passcode, so far when I click OK I get what appears to be a load bar and it blinks

And when added to task scheduler the system crashes after 5 minutes so no joy there I guess that it's not going to work on this pc I'll find another as after this works I need to run aprs in a second

Was APRSIS32.exe ever working properly on the computer without the "auto start"? Are you placing the APRSIS32.exe file in a folder that is read/write? Windows has become very particular about what

I tried both ways usually the shortcut works but not this time. I'm scratching my head on this. Tried making it a task that starts 1 minute after logon but 2 minutes after it starts the system

It sounds like you put a copy of the APRSIS32.EXE into the startup folder instead of a shortcut pointing to APRSIS32.EXE. Lynn (D) - KJ4ERJ - Author of APRSISCE for Windows

With newer operating systems, many things happen at the same time with new processors and multthreading. I find that the "Start Programs" are more for legacy work. I prefer to start things with

I moved this to the general discussion for more assistance, but crossed out the regestration infomration. This is not UI_View, so the regestration code for UI_View has no value. If you are using this

I should say, I copied the shortcut to my startup menu. Mine works Don va7qu -- Don Poaps New Westminster, BC VA7DGP DATA VA7QU VOICE Winlink: va7qu@... Subject://wl2k

I've added aprsisce to the startup folder in win 10 but it doesn't work it acts like a new installation and short cut in the folder does nothing I would like aprsisce to auto start after a reboot

Hi Jeremy I added aprsisce32 to a new windows 10 installation without any problems a few days ago. Have you followed the instruction to extract it to a folder that is not inside any of

From the APRSIS32Cafe: Thank you very much i got it to work once i pulled the .exe to a folder on the desktop. It is installed on a dell full windows labtop.

Hello All i am trying to install aprsis32 on windows 10 with no luck. any help would be great. Thanks Jeremy Wells

Uncheck Enables / Telemetry Enabled. It won't cause it to disappear from aprs.fi, but it will cause it to stop updating. Lynn (D) - KJ4ERJ - Author of APRSISCE for Windows

Ok I'm setting up a system and can't get this data to disappear. "Battery: 100 Percent, Charging/AC: 48 Charge/On/Off, GPS+Sat: 2 Sats/On/Off, A4: 500 N/A, A5: 0 N/A" It's a base system on AC mains