Re: How to make a new PORT that listens to a soundcard?
|
Rob Giuliano
Remember, that if you intend to TX from APRSISce/32 through the AGW port, it will on TX on the KISS PORT ID 0 (zero). So the best method would be: D710/Signalink/AGW combo would be KISS port 0 (zero) AGW Properties (from task bar) Port1 TNC Type: SoundCard - SoundCard Selection: USB SignaLink TNC RadioPort: APRS - Ports Kiss Id: 0 RTL/SD app/AGW combo on a different KISS port AGW Properties (from task bar) second device Port1 TNC Type: SoundCard - SoundCard Selection: Virtual Audio Cable TNC RadioPort: Satellites - Ports Kiss Id: 1 (or your choice) NOTE: TNC Radio port is the AX.25 port name which AGW dfefault is 145.650Mhz 1200baud I like to keep these simple, one word descritpions. In the example above, I changed them to APRS and Sattellite Robert Giuliano
On Tuesday, December 24, 2019, 3:44:30 PM EST, KD7YZ Bob <kd7yz@...> wrote:
On Tue, Dec 24, 2019 at 11:06 AM, Rob Giuliano wrote: > > You MUST keep the port numbers on the far right unique for each port. AGW > tends to asume a dual port TNC and starts with KISS ports IDs of 0 (zero) and > 16. When you create the second port, you must change the ports. Yikes! So far, I only select Single-Port when dealing with the D710. from any program. -- KD7YZ Bob EM88LL
|
|
|