Later update:
OK, I tried that, should I remove the other ~!!0 lines?
Ron
++++++++++++++++


> I'm following with interest as I fight the same battle at the same time
>
> Thanks  Ron
 ++++++++++++++

>> At 09:00 PM
> 6/24/2011, toddsemko wrote:
>>>Setting up with open tracker 2.
> Cant get it to work, cant find in
>>>message search.
>>
>
>> When I tried Lynn's suggestions and the APRSIS wiki suggestions
> for
>> the T2, I could not get the program to connect to the T2. I
> suspect
>> that I did not have the T2 configured correctly to start
> with. After
>> some experimentation, I came up with the following
> commands for a
>> T2-135 which is very similar to the OT2.
>>
>> ^003^003^003~
>>
> INT 0
>> WAY
> OFF
>> AMODE KISS
>> ^003^003^003~
>>
>>
> The open commands were derived from reading the Tracker 2 wiki's
>>
> suggestions for using UI-View with the T2 in KISS mode. Start out
>> using OTWinCfg to set the T2's ports to 9600 baud and automatic
>> protocol detection. The first series of Ctrl-C's gets the T2's
>> attention, then you tell it to not beacon, then you tell it to
> not
>> send GPS waypoints back to the computer, then you tell the A
> port to
>> go into KISS mode.
>>
>> Bob...
>>
>
>>
>